Kafuter K-703 45g Adhesive White Sealant Silicone Rubber Glue For Glass Metal Plastic Tiles Waterproof Insulation | Обустройство дома

Kafuter K-703 45g Adhesive White Sealant Silicone Rubber Glue For Glass Metal Plastic Tiles Waterproof Insulation | Обустройство дома

Kafuter k703 45g Adhesive White Sealant Silicone Rubber Glue For Glass Metal Plastic Tiles Waterproof Insulation Electronic Resistant Feature: 1.It has a good electrical insulation property, sealing property and aging resistance performance. 2.Widely used in bonding glass, instrumentation, refrigerators, freezers, medical equipment and small electronic components. 3.Very strong after it dries. 4.Temperature: 60C ~ 200C. 5.Excellent high temperature performance, can be used as a general adhesive sealant.  Product Features This product is a neutral one-component RTV silicone rubber to absorb moisture in the air at room temperature cured non-toxic, non-polluting, non-corrosive. Has good electrical insulation and arc resistance, anti-aging, moisture, good adhesive properties can be long-term use in the temperature range of -60 ---- 250 . long shelf life, stable performance, it can be bonded common metals and non-metallic materials, it applies between various metals, metal and non-metallic materials between the bonding and sealing.  Uses This product is used as an adhesive, sealing, insulation, moisture-proof, shock-proof material, widely used in potting adhesives, sealants, electric heater, electronic instruments waterproofing, sealing and electronic components, electronic components, semiconductor materials, electrical and electronic equipment etc. specific adhesive seal the end of the electrical heating, small motor magnetic tile adhesive and metal housing, car lights, optical instruments and lenses adhesive seal, electronic instrument enclosures adhesion, insulation protection of electrical and electronic components closing and sealing.  Technical performance Before curing Performance name K-703 Appearance milky viscous liquid Surface drying time (25 , min) ≤10  After curing Mechanical behavior Tensile strength (MPa) ≥1.0 Elongation at break (%) ≥150 Shear strength (MPa) ≥1.0 Hardness (ShoreA) 30 ~ 40 Temperature  -60 ~ 200 Electrical Properties Dielectric strength (KV / mm) 16 Dielectric constant (@ 60HZ) 2.96 Volume resistivity (Ω.cm) 2 × 1015  Instructions First Component do general cleaning, drying, sizing out of this product, plastic materials in contact moisture in the air from the metal hose, ie outside to the inside cured solid whole time no longer than 24h .  Precautions 1. For temperature components, can be cured at room temperature, then at 50 ~ 100 , humidity oven for 4 to 8 hours, rush out of low molecular weight compounds, and fully cured to ensure adhesive performance. 2. This product is in use, the hose should be tightly closed, to save again.  Note: The above data are based on our extensive obtained experimental results are reliable. However, due to the diversity of application conditions of practical application are beyond our control, so users need to be tested before use in order to confirm whether the product is suitable.